Installation For Select Traverse Wood Poles

Use wall anchors if unable to install in wall studs. ( recommend studs )

Mount end brackets at each end of track. The end brackets have a hook hole to pin drapery return to wall.

Install included support brackets spaced evenly across width of rod

1.  Adjust brackets to desired projection. To adjust loosen top screw of bracket clip to allow clip to slide forward or back. Tighten at desired Position. All brackets should be at the same projection.

2. Attach finials to end rod by screwing finial screw into the top front notched hole of wood fascia between fascia and track.

3. Attach rod to brackets by inserting front of bracket clip under top lip of track. 
Rotate cam lock clockwise and tighten over the edge of track to secure a slotted or square driver screwdriver.

4. Install cord Tension pulley.

5. Adjusting cord length with pulley upright 

On the back side of the rod on the back of the right master carrier there are two knots. 
To adjust the cord length, pull the knot closest to the end of the rod pull cord till tight. Tie a new knot as close as possible to carrier.  

To knots on right side 

6. On the left side pull cord out twist cord make loop and place over prong.
 

Right Side                            Left Side

7. Reattach cord to pulley make sure rod works right, then cut off extra cord
remember after doing so it can not be reattached.   

Track Only

Colors:

Heavy duty tracks that are constructed with wheeled carriers and metal masters with the capacity to handle today's drapery treatments. Track can be purchased separately.

Left Side                      Right side

_______________________________________